Repeater - Network Removal And Reset - Lennox 21L07 Installation Instructions Manual

Repeater – Network Removal and Reset
This procedure will remove the specific wireless
repeater (relay) from the rooftop unit group. Use
the following steps to perform the network removal
and repeater hard reset.
IMPORTANT
It is recommended that any repeater that are
taken out of use, should be removed from the
network and a hard reset performed
CORE Service App Repeater Removal
To remove the repeater (relay) from the RTU,
use the CORE Service App and navigate to RTU
Menu > Network Integration > Wireless Sensor
Network Setup.
1. Select the relay to remove.
2. Select Remove Relay at the bottom of the
screen.
3. The Remove Relay screen will appear, select
YES.
4. Press and hold the beacon button for two
seconds to remove particular node (repeater)
from the BLE mesh network.
5. Type in the relay name and select Proceed.
Repeater Hard Reset
Use the following procedure to perform a factory
reset.
1. Press and hold both the beacon and reset
buttons simultaneously for 10 seconds.
2. Release only the reset button.
3. After two seconds then release the beacon
button.
After performing the hard reset, the wireless
repeater can be added to any other rooftop unit
group or added back to same the rooftop unit
network.
22