Sensor - Data Verification; Sensor - Network Removal And Reset - Lennox 21L07 Installation Instructions Manual

Sensor – Data Verification
This step may be required to verify whether added
wireless sensor is grouped and communicating
with the rooftop unit.
Sensor data will be displayed on the CORE Service
App dashboard screen.
Sensor – Network Removal and Reset
CORE Service App Sensor Removal
To remove the node (sensor) from the RTU, use
the CORE Service App and navigate to RTU
Menu > Network Integration > Wireless Sensor
Network.
1. Select the node (sensor) to remove.
2. Select Remove Sensor at the bottom of the
screen.
3. The screen Remove Sensor will appear, se-
lect Yes to proceed.
4. Press and hold the beacon button for two sec-
onds to remove the node (sensor) from the
BLE mesh network.
5. Enter the sensor name on this screen and
select Proceed.
IMPORTANT
It is recommended that any sensors that are
taken out of use should be removed from the
network and a hard reset performed.
Sensor Hard Reset
Use the following procedure to perform a sensor
hard reset.
1. Press and hold both the beacon and reset
buttons simultaneously for 10 seconds.
2. Release only the reset button.
After two seconds release the beacon button.
3.
After performing the hard reset, the wireless sensor
can be added to any other rooftop unit group or
added back to same the rooftop unit network.
19