Table of Contents
Advertisement
Step 2: Configuring the UAV for Communication with the
Phase One Camera
1.
Download DJI Assistant 2 from the DJI website and install it on a PC.
2.
Connect a USB cable between the PC and the UAV micro USB port.
3.
Turn ON the drone.
4.
Start the Assistant 2 application. The following screen is displayed when the UAV is connected.
5.
Click the M600 / M600 Pro icon. The following screen appears.
6.
In the tree menu click 'SDK'. The following screen appears.
7.
Configure the following fields:
•
Select the 'Enable API Control' check box
•
Select the 'Ground Station Status' check box
•
Set the 'Baud Rate' to 115200
8.
Exit the application.
9.
Re-start the UAV in order for the changes to take effect.
After re-start of the system, the Assistance 2 SDK page should look as the image below:
Note: This procedure should be repeated if DJI UAV Firmware was upgraded.
6
Advertisement
Table of Contents
