Table of Contents
Advertisement
APNs varies between different service providers. Most service providers have an internet portal which
they use to connect to a DHCP Server, thus giving you access to the internet i.e. some 3G operators
use the APN 'internet' for their portal. The default value is internet.
PDN Type: Select the supported IP version, IPv4, Both IPv4/IPv6 or IPv6 only.
Authentication Protocol: Check if the ISP wants authentication, select PAP or ChAP.
Username/Password: Enter the username and password provided by your service provider. The
username and password are case sensitive.
PIN: PIN stands for Personal Identification Number. A PIN code is a numeric value used in certain
systems as a password to gain access, and authenticate. In mobile phones a PIN code locks the SIM
card until you enter the correct code. If you enter the PIN code incorrectly 3 times in a row, then the
SIM card will be blocked and you will require a PUK code from your network/service provider.
Connection: Default set to Always on to keep an always-on 3G/4G-LTE connection.
Keep Alive: Select Yes to keep the 3G/4G-LTE connection always on.
Keep Alive IP: Enter the IP address whic is used for ping, and router will ping the IP to find whether
the connection is on or not, if not, router will recover the connection.
Default Route: Select Yes to use this interface as default route interface.
NAT: Select this option to Disabled/Enable the NAT (Network Address Translation) function. Enable
NAT to grant multiples devices in LAN to access to the Internet through a single WAN IP.
MTU: Set the MTU(maximum transimission unit) value.
SMS Control: SMS(Short Message Service) allows users to send short message using your
smartphone to control the device remotely. Now it allows users to get status of LTE or remotely restart
the device, refer to the following
SMS Control
for more information.
Usage Allowance:
Mode: include Volume-based and Time-based control.
Volume-based include only Download, only Upload and Download and Upload to limit the flow.
Time-based control the flow by providing specific hours per month.
The billing period begins on: the beginning day of billing each month.
Over usage allowance action: what to do when the flow is over usage allowance, the
availablemethods are Disconnect, E-mail Alert, E-mail Alert and Disconnect.
Save the statistics to ROM: Save the statistics data to ROM system to avoid lost data if system
reboot.
50
Advertisement
Table of Contents
