Billion BiPAC 4700AZ User Manual page 14

3
SIM Card Slot
4 WiFi LED for 2.4G
5 WiFi LED for 5G
LTE LED
6 (Received Signal
Strength Indicator)
7 Power LED
8 Internet LED
9 Gigabit Ethernet WAN
10 LAN (PoE interface)
11 Ethernet LED
Insert the mini SIM card (2FF) with the gold contact facing down.
Push the mini SIM card (2FF) inwards to eject it
Warning: Before inserting or removing the SIM card, you must disconnect the
router from the power adapter.
The single-colour LED behaves as follows:
Green Wireless connection established
Green blinking Data being transmitted / received
The single-colour LED behaves as follows:
Green Wireless connection established
Green blinking Data being transmitted / received
The 4G/LTE received signal dual-colar LED behaves as shown below.
Green
Green Flashing quickly
Orange Flashing quickly
Orange Flashing slowly
Orange
Off
The Power dual-colour LED behaves as shown below.
Green System is up and ready
Red Boot failure
The Internet dual-colar LED behaves as shown below.
Green IP connected and traffic is passing through the device.
Red IP request failed.
Off Either in bridged mode or WAN connection not present.
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the four LAN ports when
connecting to a PC or an office/home network of 10Mbps/ 100Mbps/ 1000Mbps.
Note: The EWAN port is a configurable LAN/WAN port, which automatically
becomes an EWAN port when EWAN internet interface is being selected in the
GUI.
The PoE interface, pleae connect to supplied 802.3at PoE- equipped switch or power
injector.
The dual-colour LED behaves as shown below.
Green Transmission speed is at Gigabit speed (1000Mbps)
Orange Transmission speed is at 10/100Mbps
Blinking Data being transmitted/received
10
RSSI greater than -69 dBm. Excellent signal condition
RSSI from -81 to -69 dBm. Good signal condition
RSSI from -99 to -81 dBm. Fair signal condition.
RSSI less than -99 dBm. Poor signal condition.
No signal and the 4G LTE module is in service
No LTE module or LTE module fails