Bosch Rexroth SMART Flex Effector Manual page 13

13
Non-observance of the technical specifications regarding voltage
If the connection data is not observed, the SFE and the locking mechanism may
become damaged or malfunctions may occur.
 Observe the maximum DC supply cable length defined in the technical data.
 Ensure that the voltage at the device is within the stated tolerances.
Interface fault due to unearthed cables
Unearthed cables may cause an interface fault and incorrect transmissions.
 Earth the cable shield.
Damage and short-circuit due to incorrect insertion of the connector
Incorrectly inserted connectors and bent pins may cause damage to the SFE and
short-circuits.
 Ensure that the connector is inserted in the correct position when connecting
the cable, and do not bend any pins.
Damage and short-circuit due to tension on the connection cable
Tension on the connection cable pins may cause damage to the SFE and short-
circuits. This may cause changes to the behavior of the SFE.
 Avoid tensile stress on the cable.
Short-circuit due to connecting the live connector
If the connector is live, connecting it may cause damage to the SFE and short-
circuits.
 Ensure that the SFE is disconnected from power before connecting or
disconnecting the cable.
en
Caution
Caution
Caution
Caution
Caution
2
Safety