Figure 3-2 Oem Vi30/40 Rear Panel Controls And Indicators - Novanta vi30 User Manual

CONTROLS AND INDICATORS PAGE | 30
OEM vi30/40 rear panel

Figure 3-2 OEM vi30/40 Rear panel controls and indicators.

DC Power Cables – receives +48 VDC from the DC power supply. The DC power cables are
manufactured from #12 AWG wire and measure 1 meter (42 inches) in length. The red (positive) cable
contains a replaceable in-line fuse. If vi30/40 fuse replacement is required, refer to the Getting Started
section of this manual.
DB-9 I/O Connector – provides a connection point for auxiliary output power as well as input and
output signals. Refer to DB-9 I/O connections in the Technical Reference chapter for pinouts and signal
descriptions.
LASE Indicator – illuminates red to indicate that the laser is actively lasing. The LASE indicator is off
when tickle pulses are being generated and illuminates red when PWM Com-mand signal pulses are long
enough to produce laser output.
RDY (Ready) Indicator – illuminates yellow when the laser is enabled, indicating that, after an initial five-
second delay, lasing will begin when a PWM Command signal is applied.
PWR (Power) Indicator – illuminates green when +48 VDC power is applied to the laser.