ADJUSTING CHIP LENGTH
1. Lock the knife disk with lock pin A.
2. Move the anvils to their outermost position
so that the knives do not strike each other after
adjusting.
B
30
250
3. Loosen the nuts for knife holder B.
CH27 DMR
A
4. Adjust the perpendicular distance of both
ends of knife C from the edge of the knife disk.
If necessary, tap the knife holder with a wooden
or rubber mallet. The chip length can be adjus-
ted between 5-25 mm. If you would like a longer
chip length, move the knife holder farther away
from the feed chute.
65
C
5-25 mm