Table of Contents
Advertisement
OPERATION
When the speed is greater than the 'No-Stress' speed + resume percentage then operation of the
feed rollers is allowed.
Switch box operation is as follows:
Turn to operate reverse.
Display shows 'rr' when
held.
For the feed rollers forward to be 'latched on' the switch must be held in the forward position for
greater than 3 seconds.
The 'latching' time period can be set in programming mode 4. To enter the program-
ming mode press and hold the SET button while turning the instrument on, keep the SET
button pressed for a further 10 seconds and the display will show CAL 4. Press the SET
button twice more and the display will show the latching time. This can be changed by
pressing and holding the middle button. The time period can be set from 1 – 9 seconds.
0 seconds can also be set which turns the latching function off. This maybe of benefit when using
the foot switches.
Standard using with a switch box:
Programming mode 4. must be; Channel 2. is
Std and Channel 3. is 1.
Standard using with pedals:
Programming mode 4. must be; Channel 2. is
Std and Channel 3. is 1. or 0., if user want to
press the pedal continously.
CH27 DMR
Radio using:
Disconnect the switch box! Programming
mode 4. must be; Channel 2. is IN and Channel
3. is 0.
•
Start, green button (I) is Power on
•
Stop, red button (O) is Power off
•
Arrow up (1.) Push once is feed in and push
second time stop
the feed function
•
Arrow down (2.)
is reverse
40
Turn to operate forward.
Turn & hold for greater than
1 seconds to operate
forward permanently
Display shows 'fr' when
held.
Advertisement
Table of Contents
