Table of Contents
Advertisement
GENERAL SAFETY INSTRUCTIONS FOR THE
CHIPPER
!
DANGER!
1. Please make sure any machine operator
has the required personal protective equip-
ment: safety helmet, protective goggles, cut
resistant safety boots and required protecti-
ve clothing.
2. The chipper must not be used without
being mounted to a tractor.
3. For mounting or dismounting the chipper,
always turn off the tractor and apply the
parking brake before entering the area bet-
ween chipper and tractor.
4. The chipper must be on a level, firm surface
during operation.
5. Make sure all protective and safety devices
of the chipper are installed. Never remove
any protective device during operation.
6. As compared to the tractor, the chipper
must not be lowered excessively. Otherwise,
the PTO drive shaft connection may loosen
during operation.
7. It is not permitted to operate the chipper
without feed unit or feed hopper.
8. Material to be chipped must not be fed into
the manual feeder device with a grab loa-
der.
9. Indoor operation of the chipper is prohi-
bited.
10. Always keep a safe distance to the discharge
position of the chips.
11. Detach the chipper from the tractor before
performing any maintenance or repair
works. Caution! As a sole exception, adjust
the speed of the feed rollers of the hydraulic
feed with the machine running.
12. Do not remove, lock, disable or modify in
any other way the stop lever of the feed unit.
13. The feed hopper or the feed unit must not be
mounted at a higher or lower position as
this would impede the stop lever function.
CH27 DMR
!
CAUTION!
1. People are not to ride on top of the chipper.
2. The chipper may not be used indoors.
3. The chipper must only be used to chip wood.
4. The chipper may not be used in nature
reserves.
5. Avoid chipping in areas where noise and
dust will disturb the surrounding environ-
ment.
6. The chipping of highly flammable materials
is expressly prohibited.
14
Noise from the chipper ex-
ceeds 70 db in operation.
Wear ear protection!
Advertisement
Table of Contents
