KNIFE MAINTENANCE
Remove bolt A and nut B. Open the upper housing toward the discharge pipe. Lock the knife disk
during maintenance. Turn the knife disk until the hole in the disk is aligned with locking pin D. Re-
move locking pin circlip C and push the pin into the hole in the disk. Lock the pin with the circlip.
19
78
Remove knife bolts E (4 pcs), nuts F (4 pcs) and lock washers G (4 pcs). Remove knife H. Sharpen or
replace the knife. Mount the knife with bolts, lock washers and nuts. Sharpen knives in pairs to keep
lengths the same and maintain disk balance.
CH27 DMR
D
C
E
H
63
B
A
30
A = M20x280 DIN 931
B = M20 DIN 985
19
68
F
G