ADJUSTING CHIP LENGTH
1. Lock the knife disk with lock pin A.
2. Move the anvils to their outermost position
so that the knives do not strike each other after
adjusting.
B
30
250
3. Loosen the nuts for knife holder B.
CH27 ACR/ACC PROFI
A
66
C
4. Adjust the perpendicular distance of both
ends of knife C from the edge of the knife disk.
If necessary, tap the knife holder with a woo-
den or rubber mallet. The chip length can be
adjusted between 5-25 mm. If you would like
a longer chip length, move the knife holder
farther away from the feed chute.
5-25 mm