Chip Length Adjustment - Farmi 381 HFC Operation, Maintenance And Spare Parts Manual

CHIP LENGTH ADJUSTMENT

Chip length is determined by the distance between
the knives and the disc. Chip length is adjusted by
moving the knife holders. The chip length can range
between 10-30 mm.
1. Firstly, follow the "Opening and removal of the
upper chamber" instructions.
2. To extend the chip length, first remove the anvil
fastening bolts M16 (A)
3. Move the anvils further from the disc.
4. Remove the knife holder fastening nuts, M24.
Set both ends of the knives to the same distance
from the disc. Use the adjustment screws for this
purpose.
5. Tighten one of the knife holder nuts and re-check
the distance measurement at the other end.
10-30 mm
Chip length adjustment
Knife holder adjustment direction
FARMI 381 HFC / HF
Removing the knife holder nuts
Knife holder adjustment screw
33