Checking And Adjusting The Blower Latch; Greasing The Idler Arm And Handle Pivot - Toro Z Master Z500 Series Operator's Manual

6. Install the spring as shown in
Figure 34
1. Spring-loaded idler pulley
2. Short-hook end
7. Pull back on the spring-loaded idler pulley and
install the belt onto the spring-loaded idler pulley
(Figure 33).
Checking and Adjusting the
Blower Latch
Close the blower assembly to see if the latches are
adjusted correctly. Loosen or tighten the bolts so the
latches firmly hold the blower assembly against the
mower deck but can be released by hand.
Figure 35
1. Latch
2. Bolt
Figure 34.
g003638
3. Long-hook end
g003400
3. Blower assembly
Greasing the Idler Arm and
Handle Pivot
Service Interval: Every 50 hours—Grease the idler
arm.
Every 100 hours—Grease the handle pivot.
Grease the blower belt idler arm
Grease the handle pivot
24
(Figure 36).
Figure 36
(Figure 37).
Figure 37
g003455
g009229