Sizing The Upper Tube For 152 Cm (60 Inch) Mowers With Gas Engines; Installing The Discharge Tubes - Toro Z Master Z500 Series Operator's Manual

8
Sizing the Upper Tube for
152 cm (60 inch) Mowers
with Gas Engines
Parts needed for this procedure:
1 Upper tube
Procedure
Note:
This procedure is for 152 cm (60 inch) mowers
with gas engines only.
1. Measure up 89 mm (3-1/2 inches) from the
bottom of the upper tube. Use the existing 3
holes as marks and then mark it in several
places to create a line around the tube
18).
2. Cut the 89 mm (3-1/2 inches) off the upper tube
(Figure 18).
Note:
Notice the three indentations in the tube.
This is where holes will be drilled in the following
procedure.
(Figure
1. Indentations for drilling
holes
2. Upper tube
3. Cut off 89 mm (3-1/2
inches) for 152 cm (60
inch) mowers with gas
engines only
9
Installing the Discharge
Tubes
Parts needed for this procedure:
1 Upper tube
1 Lower tube
3 Bolt (#10 x 3/4 inches)
3 Locknut (#10)
3 Washer (7/32 inch)
Procedure
Important:
the lowest height-of-cut position while installing
the discharge tubes.
13
Figure 18
4. Use the existing holes to
create a line
5. Line to cut tube
Make sure that the mower deck is in
g003391