Toro Z Master Z500 Series Operator's Manual page 12

Figure 14
183 cm (72 inch) Mower Deck
1. Blower assembly
2. Mower deck, 183 cm (72
inch) shown
3. Close the blower assembly to see if the latches
are adjusted correctly
Note:
Loosen or tighten the bolt so the latches
firmly hold the blower assembly against the
mower deck but can be released by hand
(Figure 15).
Figure 15
1. Latch
2. Bolt
4. Install the spring as shown in
g003377
3. Pivot hole
4. Blower-assembly peg
(Figure 15).
g003400
3. Blower assembly
Figure 16.
Note:
Make sure that the hooks are in the
correct position.
1. Spring-loaded idler pulley
2. Short-hook end
5. Pull the spring-loaded idler pulley back and
route the belt around the mower-deck pulley
(Figure 17).
Note:
Ensure that the belt is routed around the
blower pulleys correctly
1. Mower-deck pulley
2. Spring-loaded Idler pulley
12
Figure 16
3. Long-hook end
(Figure 17).
Figure 17
3. Blower
g003638
g003399