Installing The Belt Cover - Toro Z Master Z500 Series Operator's Manual

10. Using the 3 holes or indentations in the upper
tube as a template, drill 3 holes (7/32 inch
diameter) where the upper and lower tubes join
together (Figure
1. Bagger hood
2. Upper tube
3. Drill 7/32 inch diameter
holes here (use the upper
tube as a template)
11. Remove the lower tube from the blower.
24).
Figure 24
4. Lower tube
5. Blower assembly
12. Join the upper and lower tubes with 3 bolts (#10
x 3/4 inches), 3 flat washers (7/32 inch), and 3
locknuts (#10) as shown in
g003390
1. Lower tube
2. Upper tube
3. Flat washer (7/32 inch)
13. Install the lower tube onto the blower housing
and secure it with the latches.
10

Installing the Belt Cover

Parts needed for this procedure:
1 Belt cover (from the Blower and Drive Kit)
Procedure
1. Lower the mower deck to the lowest height-of-cut
position.
2. Install the new belt cover so that the notches on
both sides go over the belt-cover supports and
secure the latch
16
Figure 25.
Figure 25
4. Locknut (#10)
5. Bolt, (#10 x 3/4 inches)
(Figure 26).
g003392