aventon Soltera 7 User Manual page 15

Battery Charging Information
Check the charger, charger cables, and battery for damage before beginning each charge.
Be sure to charge in an area where it is clear and safe from any potential damage or tripping situations
can occur while it is charging. Always charge indoors in a cool and dry area and away from direct sunlight,
dirt, or debris. Always charge your battery in temperatures between 50 °F – 77 °F (10 °C – 25 °C).
The battery can be charged on or o the bike. To remove the battery, turn the key to the unlocked position,
pull the lever and take the battery out.
The battery should be recharged after each use, so it is ready to go the full range for your next ride. There
is no memory e ect, so charging the battery after short rides will not cause damage.
Charging the battery normally takes 3-7 hours.
The charge indicator lights will show red light while the battery charges. When charging is complete, the
indicator light will turn green. Ensure the light faces upward when charging.
Remove the charger from the battery within one hour of the green light indicating a complete charge.
The charger is designed to automatically stop charging when the battery is full, but unnecessary wear of
the charging components could occur if the charger is left attached to the battery and a power source for
longer than 12 hours.
Indicator light on the battery: Blue - More than 66%. Green - 33%-66%. Red - Less than 33%
Never charge a battery for more than 12 hours at a time.
DO NOT leave a charging battery unattended.
Failure to follow Battery Charging Information could result in unnecessary wear to the charging
components, battery, and or charger, and could lead to an underperforming or non-functional battery
and replacement will not be covered under warranty.
Use caution to avoid damage to battery connector terminals, which are exposed when the battery is
unlocked and removed from the frame of the bike, In the case of damage to the terminals or battery
mounts, please discontinue use and contact Aventon Support immediately
REMOVING THE BATTERY
Ensure the bike is turned o , turn the key to the unlocked position.
Pull the battery lever and gently pull the battery outwards of the tray with one hand holding the battery.
Make sure it won't hit the fork.
DO NOT touch or damage the "+" and "-" terminal contacts on the top of the battery and keep them clear
of debris.
WHEN INSTALLING THE BATTERY ONTO THE BIKE
DO NOT force the battery into the tray; slowly align and gently push the battery down into the tray.
Make sure there is no space between battery and tray, confirm battery has been fully secured on the tray.
Ensure the battery has been properly secured to the bike before each use by carefully pulling outwards
on the battery with both hands once locked.
15