Fig. 16: Soaking Contamination Of The Turbine; Table 12: Dimensions Of The Cleaning Container - ABB HT600042 Operation Manual

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
7 Periodic maintenance work / 7.2 Cleaning components mechanically
Dispose of dirty water and cleaning agents in accordance with the material safety data
u
sheet.
7.2.7 Cleaning the cartridge group on turbine end
Soaking the contamination
Baked layers of contamination from fuel residue or coked oil may occur at the turbine end.
The contamination can be removed by soaking and brushing. The procedure for soaking the
layers of contamination as well as for cleaning the turbine are described in the following.
Fig. 16: Soaking contamination of the turbine
Product
TPS44
TPS48
TPS52
Table 12: Dimensions of the cleaning container
To soak the layers of contamination on the turbine, the cartridge group can be immersed
vertically in a container (02) with fluid.
Place the container (02) inside a larger container (03) so that the overflowing fluid can be
u
collected.
CAUTION
Selection of the cleaning agent
Cleaning agents which contain chlorine attack metals.
Use only pH-neutral cleaning agents which do not attack metals.
u
Observe safety data sheet.
u
Fill the container (02) with soaking fluid. To shorten the soaking time, the fluid can be
u
heated up to a maximum of 60 ºC.
© Copyright 2017 ABB. All rights reserved.
A [mm]
115
115
135
HZTL4037_EN
B [mm]
20
29
35
Revision E
C [mm]
155
180
215
July 2017