Important Safety Instructions - Hatco HDW-1R2 Series Installation & Operating Manual

IMPORTANT! Read the following important safety instructions to avoid personal injury or death,
and to avoid damage to the equipment or property.
WARNINGS
Plug unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do not
match, contact a qualified electrician to determine
the proper voltage and size and install the proper
electrical outlet.
To avoid any injury, turn the power switch off
at the fuse disconnect switch/circuit breaker
or unplug the unit from the power source and
allow to cool completely before performing any
maintenance or cleaning.
For safe and proper operation, the unit must
be located a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion
could occur.
To avoid electric shock or personal injury, do not
steam clean or use excessive water on the unit.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when service
is required.
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the characteristics
that will allow them to operate safely in Hatco
equipment. It is essential to use Hatco
Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in electrical
shock or burn.

IMPORTANT SAFETY INSTRUCTIONS

Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to
avoid injury.
The National Sanitation Foundation (NSF)
requires that HDW-1R2 Series units over
36" (91 cm) in length or weighing more than
80 lbs. (36 kg) to be either sealed or raised on the
installation surface. If this unit cannot be sealed at
the point of use, 4" (10 cm) legs are included to
allow for proper cleaning access below unit. See
INSTALLATION instructions for details.
Locate the unit at the proper counter height, in
an area that is convenient for use. The location
should be level to prevent the unit or its contents
from accidentally falling, and strong enough to
support the weight of the unit and food.
To avoid any injury, use caution when opening
drawer. Hot air escapes when drawer is open.
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring its appearance and making it susceptible
to soil accumulation.
Do not lay unit on the front or back side or
damage to unit could occur.
1
CAUTIONS
CAUTIONS
Form No. HDW1R2M-0502