Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest assembly.
2. Route the speaker cable through the routing guide on the assembly inner frame and palm-rest assembly.
3. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the
3-cell battery
2. Install the
base
cover.
3. Install the
microSIM
card.
4. Install the
microSD
card.
5. Follow the procedure in
Moderkort
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
microSD
3. Remove the
microSIM
4. Remove the
base
cover.
5. Remove the
3-cell battery
6. Remove the
M.2 2280 solid-state drive
7. Remove the
WLAN
card.
8. Remove the
WWAN
card.
9. Remove the
memory
module.
10. Remove the
heat-sink
11. Remove the
assembly inner
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
44
Ta bort och installera komponenter
or
4-cell
battery.
after working inside your
before working inside your
card.
card.
or
4-cell
battery.
or
M.2 2230 solid-state
assembly.
frame.
computer.
computer.
drive.