Change Advanced Settings - Siemens RDS110 User Manual

A6V10877569_en--_f
●
Configure the output as a free-standing humidifier, a free-standing dehumidifier
or a domestic hot water boiler.
●
Activate or deactivate the optimum start settings for heating. Activating
optimum start settings allows for pre-heating unoccupied spaces (a scheduled
"Unoccupied" mode is active) to reach the scheduled temperature setpoint at
the scheduled occupancy (the thermostat enters "Comfort" mode).
*) If 0...10 V is selected as signal type, a DC 0..10 V active sensor must be
connected to the thermostat, or the calculated value may be inaccurate.

Change advanced settings

1. On the "Advanced Settings" page, tap .
2. When prompted, enter the administrator password.
3. Tap > .
4. Tap "OK" to stop all thermostat applications. The thermostat restarts.
5. After restarting, tap "I/O" > "Adapt".
6. Change the settings as desired.
Operating the thermostat on the device
Advanced settings
6
39 | 59