Maintenance; Cleaning; Light Bulb Replacement (Gr2Bw Only) - Hatco GR2BW-24 Installation & Operating Manual

MAINTENANCE

CLEANING

The Hatco Glo-Ray Designer Foodwarmers
are designed for maximum durability and performance
with minimum maintenance.
WARNING
To avoid any injury, turn the power switch
off at the fuse disconnect switch/circuit breaker
or unplug the unit from the power source
and allow to cool completely before performing
any maintenance or cleaning.
WARNING
To prevent electric shock, always unplug the unit
before performing cleaning or maintenance.
WARNING
To prevent any injury, discontinue use if power cord
is frayed or worn.
WARNING
Unit is not waterproof. To avoid electrical shock
or personal injury DO NOT submerge in water.
Do not operate if it has been submerged in water.
WARNING
To avoid electrical shock or personal injury, do not
steam clean or use excessive water on the unit.
To preserve the finish of the Glo-Ray Designer
Foodwarmers, it is recommended that the surfaces
be wiped daily with a damp cloth. Food pans should
be removed and washed. Stubborn stains may
be removed with a good non-abrasive cleaner. Hard
to reach areas should be cleaned with a small brush
and mild soap.
CAUTION
Use only non-abrasive cleaners. Abrasive cleaners
could scratch the finish of your unit marring
its appearance and making it susceptible to soil
accumulation.
Clean the breath protector(s) with a common
glass cleaner and soft cloth.
CAUTION
Only soft cleaning cloths should be used to clean
breath protector(s). Breath protector(s) are made
of shatterproof polycarbonate and will scratch
if proper care is not taken.
Form No. GR2S/2BWM-0203
LIGHT BULB REPLACEMENT
(GR2BW ONLY)
The display lights are incandescent light bulbs which
illuminate the warming area. These bulbs have a special
coating to guard against injury and food contamination
in the event of breakage.
1. To replace a bulb, disconnect the power supply
from the unit and wait until the unit has cooled.
2. Bulbs have a threaded base. Unscrew the light bulb
from the unit and replace it with a new specially
coated incandescent bulb.
NOTE: Hatco shatter-resistant light bulbs meet N.S.F.
standards for food holding and display areas. For 100,
120, 120/208 and 120/240 Volt applications, use Hatco
part #02.30.043.00. For 220, 240, 220-230 and 230-240
Volt applications, use Hatco part #02.30.058.00.
Only bulbs which meet or exceed N.S.F. standards,
specifically designed for food holding areas, must
be used. Breakage of bulbs not specially coated could
result in personal injury and/or food contamination.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents
and Genuine Hatco Parts when service is required.
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which they
are used. Some aftermarket or generic replacement
parts do not have the characteristics that will allow
them to operate safely in Hatco equipment.
It is essential to use Hatco Replacement Parts when
repairing Hatco equipment. Failure to use Hatco
Replacement Parts may subject operators
of the equipment to hazardous electrical voltage,
resulting in electrical shock or burn.
8
WARNING
WARNING
WARNING
WARNING