Page 1
GLO-RAY Designer Infrared Foodwarmers GR2A & GR2AH Series Operating Manual This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor.
Designer Infrared Foodwarmers in the spaces below. Please have this information available when calling Hatco for service assistance. Model No. ____________________________________ Serial No. ____________________________________...
Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement...
MODEL DESCRIPTIONS ALL MODELS The Glo-Ray Designer Infrared Foodwarmers are ideal for holding hot food on pass-through holding areas and waitress pick-up stations. All Designer models are constructed of aluminum. The advanced Glo-Ray Dual Models allow side-by-side mounting of two or more aluminum warmers, to provide a wider holding area, with a 3"...
ELECTRICAL RATING CHART – GR2AL MODELS Model Voltage GR2AL-18 120/208* 120/240* GR2AL-24 120/208* 120/240* GR2AL-30 120/208* 120/240* GR2AL-36 120/208* 120/240* GR2AL-42 120/208* 120/240* GR2AL-48 120/208* 120/240* GR2AL-54 120/208* 120/240* GR2AL-60 120/208* 120/240* GR2AL-66 120/208* 120/240* GR2AL-72 120/208* 120/240* GR2AL-84 120/208* 120/240* * Units rated for 120/208 or 120/240 volt are manufactured with a 120 volt circuit for the incandescent lights and a 208 or 240 volt circuit for the heating element(s).
3" (8 cm) between warmers. Damage to countertop material such as Corian similar products caused by heat generated from Hatco equipment is not covered under the Hatco warranty. Contact the manufacturer of the base material for application information.
Figure 6. Installing Unit NOTE: GR2A series units mounted to a metal surface may require a backing plate installed to the underside of the surface in order to increase unit stability. (Backing plate not supplied by Hatco). 6" 6" Form No. GR2AM-0601...
INSTALLATION RMB (REMOTE CONTROL BOX) All models are furnished with a remote control box (RMB). Each RMB comes equipped with the applicable switches for operating the unit. Each heating element is controlled by its own on/off toggle switch or an optional adjustable infinite temperature control.
Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco...
Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer’s sole expense.
HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. Svc. Birmingham 205-251-0159 ARIZONA Auth. Comm. Food Equip. Phoenix 602-234-2443 Byassee Equipment Co. Phoenix 602-252-0402 CALIFORNIA Industrial Electric Huntington Beach 714-379-7100 Chapman Appl. Service San Diego 619-298-7106 P & D Appliance S. San Francisco...