Operation; All Models; Gr2Bw Only - Hatco GR2BW-24 Installation & Operating Manual

ALL MODELS

CAUTION
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
1. Plug unit into an electrical outlet of the correct
voltage, size and plug configuration. See
Specifications for details.
WARNING
To prevent any injury or damage to the unit do not
pull unit by power cord.
2. Turn the main toggle switch to the ON position.
Indicator light will glow when unit is energized.
See Figure 6.
3. Turn the thermostat to the desired temperature
settings. (Toggle switch must be ON for thermostat
to function.)
4. Allow unit 15-20 minutes to reach operating
temperature.
WARNING
For safe and proper operation do not place food
product directly onto hardcoat surface. Food product
must be wrapped, boxed or on a food pan.

GR2BW ONLY

The infrared heat and incandescent lights are controlled
by the toggle switch. This switch must be in the ON
position when in use. If the unit is equipped with
an optional infinite switch, this switch will control
the top heat and the toggle switch will control the lights
only. See Figure 7.
ON/OFF Toggle Switch
OFF
ON
Indicator Light
Figure 6. Operating Controls - GR2S
ON/OFF Toggle Switch
0 l
OFF ON
Indicator Light
Figure 7. Operating Controls - GR2BW
7

OPERATION

80 F 200 F
HATCO CORPORATION, Milwaukee, WI
28 C 93 C
Thermostat Control
Thermostat Control
0 OFF
HIGH
LOW
1 7
2 6
200 F
80 F
HATCO CORPORATION, Milwaukee, WI
3 5 28 C 93 C
4
Infinite Control
Form No. GR2S/2BWM-0203