Prerequisites For Ssg Unconfig; Configuration Of Ssg Unconfig; Configuration Examples For Ssg Unconfig - Cisco OL-4387-02 Configuration Manual

SSG Unconfig

Prerequisites for SSG Unconfig

You must enable SSG before you configure SSG Unconfig.

Configuration of SSG Unconfig

To configure SSG Unconfig, perform any of the following optional tasks:
•
•
•
For more information, refer to the

Configuration Examples for SSG Unconfig

Example 11-1
Example 11-1 Unconfiguring SSG and Releasing System Resources
Router(config)# no ssg enable force-cleanup
04:35:02: Delete all active host objects. It may take some time, please wait.
04:35:-02: ssg_unconfig_proc: UNCONFIGURATION COMPLETE
Example 11-2
that all host objects on that interface are removed.
Example 11-2 Removing Host Objects on an Interface
Router# clear ssg host range 0.0.0.0 255.255.255.255 FastEthernet0/1
Router# show ssg host FastEthernet0/1
##Total HostObject Count:0
For more configuration examples, refer to the
Cisco 10000 Series Router Service Selection Gateway Configuration Guide
11-6
Unconfigure SSG and release system resources by entering the no ssg enable force-cleanup
command in global configuration mode.
Remove one or more SSG host objects by entering the clear ssg host command in privileged EXEC
configuration mode.
Remove one or more SSG service objects by entering the clear ssg service command in privileged
EXEC configuration mode.
shows how to unconfigure SSG and release system resources.
shows how to remove all host objects associated with a downlink interface and then verify
SSG Unconfig, Release 12.2(15)B feature
SSG Unconfig, Release 12.2(15)B feature
Chapter 11 Miscellaneous SSG Features
module.
module.
OL-4387-02