Table of Contents
Advertisement
Chapter 6
Service Connection
A SESM configuration option controls the SESM action when a subscriber is already logged into one
service and then selects another service in the group:
•
•
Note
SESM waits for the first service to be disconnected before requesting connection to the new service. If
the connection to the new service fails, the subscriber is not connected to either service.
Configuration of Mutually Exclusive Service Selection
You define a mutually exclusive service group in a service group profile by using the Account-Info
attribute. The value TE indicates that the service group is mutually exclusive.
For more information, refer to the
Configuring RADIUS
Installation and Configuration Guide, Release
Configuration Example for Mutually Exclusive Service Selection
Example 6-5
Example 6-5
MutexGrp1 Password = "groupcisco", Service-Type = Outbound
Account-Info = "IBandwidth-QoS",
Account-Info = "Nbw-gold",
Account-Info = "Nbw-silver",
Account-Info = "Nbw-bronze",
Account-Info = "TE"
OL-4387-02
SESM can automatically request SSG to disconnect the first service and connect the new service.
SESM can prompt the subscriber to log off the first service. After the subscriber logs off, SESM
requests the connection to the other service.
in the
Cisco Subscriber Edge Services Manager and Subscriber Policy Engine
shows a mutually exclusive service group configuration that uses a Merit RADIUS format.
Configuring a Mutually Exclusive Service Selection Group
"Configuring Service Group Profiles"
3.1(3).
Cisco 10000 Series Router Service Selection Gateway Configuration Guide
Mutually Exclusive Service Selection
section in
Appendix D,
6-9
Advertisement
Table of Contents
