Related Manuals for Wali PTT008
Summary of Contents for Wali PTT008
- Page 1 Monitor Stand Riser www.walielectric.com support@walielectric.com RATED 20kg/44lbs 1-844-SATTLER (18447288537)
- Page 2 Supplied Parts List Board Support Stand Board Bolt A (x1) B (x2) C (x1) D (x6) E (x6) Wood Dowel Pin Anti-skid Pad Cellphone Holder Sticker F (x4) G (x4) H (x1) I (x6) Caution: Frequently assembling and disassembling may cause damage to the wood board. Step 1 Place Support Stand B on a flat surface, insert the Bolt D to the center hole on Support Stand B and tighten with a screwdriver.
- Page 3 Step 3 Insert Board C to the Bolt D and Wood Dowel Pin F on Support Stand B and tighten the Nut E clockwise to fasten for stability. (Screwdriver not included)
- Page 4 Step 4 Attach the Nut E to the hole on Support Stand B as the image shown. Caution: Please make sure the arrow on the nut is pointing upright towards the hole on the Support Stand B as the image shown.
- Page 5 Step 6 Insert the assembled support stand to the Bolt D on Board A . Step 7 Tighten the Nut E clockwise to fasten for stability. (Screwdriver not included)
- Page 6 Step 8 Insert the Cellphone Holder H to the designated position on Board A . Notice: The Cellphone Holder is removable. Push it from the back of the Board A to remove it if necessary. Optional Step Tear off the Anti-Skid Pad G and sticker I , attach it to the designated position as the image shown.