Page 2
Supplied Parts List Board Support Stand Bolt A(×1) B(×2) C(×4) D(×4) Anti-skid Pad Cellphone Holder Sticker E(×4) F(×1) G(×4) Caution: Frequently assembling and disassembling may cause damage to the wood board. Step 1 Place Board A on a flat surface with bottom upward, insert the Bolt C to the hole on Board A and tighten with a screwdriver.
Page 3
Step 2 Attach the Nut D to the hole on Support Stand B as the image shown. Caution: Please make sure the arrow on the Nut D is pointing upright towards the hole on the Support Stand B as the image shown. Step 3 Insert Support Stand B to the Bolt C on Board A .
Page 4
Step 4 Tighten the Nut D clockwise to fasten for stability. (Screwdriver not included) Step 5 Insert the Cellphone Holder F to the designated position on Board A . Notice: The Cellphone Holder F is removable. Push it from the back of the Board A to remove it if necessary. Optional Step Tear off the Anti-Skid Pad E and Sticker G, attach it to the designated position as the image shown.