Page 2
Supplied Parts List Center Board Left Board Right Board Center Support Stand Side Support Stand A (x1) B (x1) C (x1) D (x2) E (x2) Bolt Metal Retainer Pin Sticker Storage Slot F (x8) G (x8) H (x2) I (x8) J (x2) Caution: Frequently assembling and disassembling may cause damage to the wood board.
Page 3
Step 2 Place Board A B C on a flat surface with bottom upward, insert the Bolt F to the hole on Board A B C and tighten with a screwdriver. (Screwdriver not included) Caution: Please make sure the Bolt C is vertically straight at an 90° angle to the surface of Board A B C as the image shown.
Page 4
Step 3 Insert Center Support Stand D to the Center Board A . Insert Side Support Stand E to the Left and Right Board B C . Tighten all the Nut G clockwise to fasten for stability. (Screwdriver not included)
Page 5
Step 4 Insert Metal Retainer Pin H to the hole on Center Board A. Step 5 Insert Metal Retainer Pin H on Center Board A to the pre-drilled slot on Left and Right Board B C . Combine the three boards and prevent the Left and Right Board B C from sliding out.
Page 6
Step 6 Insert the Storage Slot J to the designated position on Left and Right Board B C . Notice: The Storage Slot J is removable. Push it from the back of the Board to remove it if necessary. Optional Step Tear off the sticker I and attach it to the designated position of Support Stand D E as the image shown.