Advertisement
4.Setup
Please follow the steps described below to set up this product.
Do not handle this product during an electrical storm.
When installing this product in the server, please read the user's guide of the server and unplug
the power plug from the electrical outlet. Do not insert or remove the power plug with wet hands.
Doing so can lead to faults or electric shock.
Do not pull on the lead when unplugging the power plug from the electrical outlet. Doing so can
damage the power cord and lead to shorting or electric shock.
Avoid installation in extreme temperature conditions.
Immediately after the server is powered off, its internal components such as hard disks are very
hot. Leave the server until its internal components fully cool down before installing/removing any
component.
Connect firmly.
Please connect the product to the server firmly. A loose connection can cause a contact failure
and can lead to smoke or fire.
Explained in this User's Guide
Installation of a bracket
Selection of a bracket to use for this product.
Installation to the server
Install this product to the server.
Network cable connection
Connect a network cable to this product.
Installation of a LAN driver
Install an appropriate LAN driver for operating system.
See the Maintenance Guide of the sever
Advertisement
