Connecting The Cables - Cisco MC16E Installation Manual

Removing and Replacing a Cisco uBR10-LCP2-MC16x Cable Interface Line Card
Figure 11

Connecting the Cables

When fully inserted, the cable interface line card cycles through its power-on self-test. The Power LED
comes on (green) and the Status LED comes on (yellow). If the card is operating correctly, the Status
LED then turns green. If these LEDs do not operate as described, refer to the
Cisco uBR10-LCP2-MC16x Cable Interface Line Card" section on page 27
Universal Broadband Router Hardware Installation Guide at the following URL:
http://www.cisco.com/en/US/docs/cable/cmts/ubr10012/installation/guide/hig.html
Cisco uBR10-LCP2-MC16C/MC16E/MC16S Cable Interface Card for the Cisco uBR10012 Router
22
Closing the Ejector Levers
CI SC O
CI SC O
10 00 0
10 00 0 CI SC O
10 00 0
CI SC
10 0
"Troubleshooting the
and the Cisco uBR10012
OL-2872-02