Cisco MC16E Installation Manual page 8

Cisco uBR10-LCP2-MC16C/MC16E/MC16S Overview
Figure 6
Figure 6
The Cisco uBR10-LCP2-MC16S cable interface line card has one downstream port and six upstream
ports. The upstream ports are labeled US0 through US5. The downstream port is labeled DS. There are
six LEDs labeled MGR ACT (manager active) next to each upstream port. See
of the LCP2 adapter card LEDs and
LEDs and their functions.
Cisco uBR10-LCP2-MC16x LEDs
Both the Cisco uBR10-LCP2 adapter card and the cable interface line card have their own set of status
LEDs on the front of the module. The Cisco uBR10-LCP2 adapter card LEDs are described in
The Cisco uBR-MC16x cable interface line cards LEDs are described in
Table 3
Table 3 Cisco uBR10-LCP2 Adapter Card LEDs and Their Functions
LED
Power
Status
Status LED on N+1 or
redundant card in chassis
Maintenance
Table 4 on page 8
Table 4 Cisco uBR-MC16x Cable Interface Line Card LEDs and Their Functions
LED Status
Enables Green
Off
Upstream Green
Off
Cisco uBR10-LCP2-MC16C/MC16E/MC16S Cable Interface Card for the Cisco uBR10012 Router
8
shows the faceplate for the Cisco uBR10-LCP2-MC16S cable interface line card.
Cisco uBR10-LCP2-MC16S Faceplate
describes the LCP2 adapter card LEDs and their functions.
Status Description
Green Indicates that the power is being supplied to the Cisco uBR10-LCP2.
Off Power is off.
Yellow Indicates that the Cisco uBR10-LCP2 is in the boot up process, is in self
test mode, or is downloading code.
Green Indicates that the Cisco uBR10-LCP2 has successfully completed the
boot, the self test, and the code download process.
Blinking Green Indicates that the board is in standby or protect card mode.
Off Normally off to indicate that there is no maintenance action required.
Yellow Indicates that it is safe to remove the entire assembly (Cisco uBR10-LCP2
adapter card and Cisco uBR-MC16x cable interface line card) from the
chassis.
describes the cable interface line card LEDs and their functions.
Description
Cable interface line card is operating normally, is receiving DC power from the router
midplane, and is configured for operation.
Either the card is shut down or the slot is not working.
Upstream path is enabled and configured (each upstream port).
Either the port is not properly configured or is shut down, or the slot is not working.
uBR - MC16S
Table 4 on page 8 for descriptions of the cable interface line card
+42 dBmV
Table 3 for a description
Table
.
Table 4 on page 8
OL-2872-02
3.