Advertisement
Changing the diffuser:
The QTX Pixel-Bar comes supplied with 2 diffusers, white and clear. Replacing one with the other is a very
simple procedure. Firstly remove the 4 screws from one end of the unit and remove the end cap. Next
slide the diffuser out and carefully replace with the alternative one. Finally replace the end cap and screws
ensuring it's in alignment before tightening.
Specifications:
Power supply
Power consumption
Fuse rating
LED type
LED quantity
Modes
DMX channels
Dimensions
Weight
Troubleshooting:
No power (mains)
No light output
Unresponsive to DMX
Overheating/
cutting out
This product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste
at the end of its useful life. The goods must be disposed of according to your local council guidelines
Errors and omissions excepted.
Copyright© 2022 AVSL Group Ltd, Unit 2 Bridgewater Park,
Taylor Road, Trafford Park, Manchester. M41 7JQ.
www.avsl.com
110-240Vac, 50/60Hz (IEC)
60W
F3A
SMD 5050 RGB
224
Static colour, colour change, colour fade, auto, sound active,
DMX, master/slave
3, 5, 8, 24, 48, 53
1100 x 60 x 60mm
1.35kg
Check mains voltage is correct and outlet is switched on
Check IEC lead and fuse (if fuse continually blows, refer to your dealer)
Check control panel mode settings
Check DMX settings from controller (dimmer levels, blackout etc.)
Check that unit is in DMX mode and ensure the A on the DMX address flashes
to confirm it's receiving a DMX signal
Check DMX controller is not set to black out
Check DMX controller is on correct fixture/page
Check master dimmer value
Check correct DMX address is set
Check DMX connection and leads
Ensure adequate ventilation and unit is not too close to a heat source
AVSL (Europe) Ltd, Unit 3D North Point House,
North Point Bus. Park, New Mallow Road, Cork, Ireland.
151.594UK User Manual
.
Advertisement
