Table of Contents
Advertisement
Specifications
Power
Power consumption
Fuse rating
LED type
Beam angle
DMX channels
Height adjustment
Dimensions : PAR bar
Weight
LED safety standard
Troubleshooting
No power (mains)
No light output
No strobe output
Unresponsive to DMX
Overheating/
cutting out
Foot control not
working
Check mains voltage is correct and outlet is switched on
Check IEC lead and fuse (if fuse continually blows, refer to your
dealer)
Check control panel mode settings (standby, slave, sensitivity, DMX)
Check DMX settings from controller (dimmer levels, blackout etc.)
Check foot control ensure unit not in black out mode
Check strobe settings on control panel or from DMX controller
Check Mic sensitivity is not set to minimum
Check DMX connection and leads
Check that unit is in DMX mode and ensure DMX address remains lit
to confirm receiving DMX signal
Check DMX controller is not set to black out
Check DMX controller is on correct fixture/page
Check master dimmer value
Check correct DMX address is set
Check that the unit is not too close to a heat source
Check wireless function is enabled on the light unit
Check control has battery inserted and battery is not flat
Check antennas on both light unit and control are lifted
Check the unit and control is not located next to wireless router as
interference may occur
110-240Vac, 50/60Hz (IEC)
130W
T3.15A
4 x 30W RGBW COB LED and 4 x
1W white LED
14-36°
3, 6 or 28
1.5 - 2.5m
1023 x 215 x 71mm
11.2kg
BSEN62471:2008
151.557UK User Manual
Advertisement
Table of Contents
