Table of Contents
Advertisement
6. Install the bushing into the lower hinge on the bottom left support bracket. Remove the decorative
screws from the left corner of the door and install and tighten them to the right corner holes.
Remove the plastic cap from the top left corner of the door and insert it into the top right corner.
7. Carefully insert the door into the upper right corner hinge, then slide the door on top of the lower
hinge and secure the door by installing the lower screws.
Installing the Casters
1. Tilt the unit on its back on a level surface and remove the 4 cabinet legs (Fig.3 number 4).
Reserve the cabinet legs.
2. Assemble the casters with brake (Fig. 2) on the cabinet front bottom and the other 2 casters
(Fig.1) at the cabinet rear bottom.
3. Assemble each caster to the bottom of the unit with (2) M5x10 screws with a Phillips screwdriver
(Fig.3).
4. The caster brake (Fig.3) at the front bottom of the cabinet comes with a braking function. When
the brake handle is "ON" (Fig.2)' unit wont roll; when brake handle is "OFF" (released), it will roll.
(Fig.2).
6
7
13
Advertisement
Table of Contents
