Installing The Door Handle; Installing The Shelves; Removing The Shelves - EdgeStar CBR1501SSOD Owner's Manual

Installing the Door Handle

To install the door handle:
1. Remove the four screws from the side of the door. This should be the side opposite of
the door hinge.
2. Place and align the openings of the handle hinges over the screw holes.
3. Insert and tighten the screws to hold the handle in place.
Warning: Do not over-tighten the screws as this may cause damage to the handle or the
!
stainless steel door.

Installing the Shelves

To prevent damaging the door gasket, make sure to open the door fully before pulling the
shelves off their tracks.
1. Open the door completely.
2. Slide the shelf on the shelf track and slowly push back until it stops.
3. Install the plastic notches.

Removing the Shelves

1. Open the door completely.
2. If necessary, make sure you remove all the contents sitting on the shelf.
3. Remove both of the plastic notches with a screwdriver.
4. Pull the shelf forward until it is completely removed from the inner compartment.
11