Table of Contents
Advertisement
SERVSHIELD
SERVSHIELD
3.1 Leveling the Cabinet
ServShield cabinets are shipped with both casters and leveling glides for your convenience. Two casters have
brakes that you can activate by turning the brake level on the side of the wheel. You can lower the leveling legs
by turning the leveling glide to the proper height using a
3.2 Removing the Doors
The top and bottom front doors and the rear door are removable. To remove a door, open the door beyond 90
degrees. Then grasp the door with both hands, and carefully lift upward. When the door is free of the hinge
pins, pull the door away from the enclosure. To attach the door, align all of the hinges (two on the front doors
and three on the rear door) and slowly slide the door down until seated.
3.3 Fan Assembly (RF207) and Rear Door Fan Filter (RM475)
The fan assembly is already installed in the rear door. The part number for the rear fan filter is RM475. If you
need to replace a filter, follow these steps:
1. Replace one filter at a time. The 12 screws, which hold the filters in place, are the only thing holding on
the fan assembly. If you replace one filter at a time, you only have to remove four screws at a time so you
don't have to remove the fan assembly.
2. Remove the fan filter cover—it snaps off.
3. Remove the four #8-32 x
4. Replace the filter, using the same four #8-32 x
5. Replace the fan filter cover.
6. Repeat steps 2 through 5 for the remaining two filters.
6
3. Installation
3
⁄
" screws holding the filter on the door.
4
3
⁄
" screws.
4
3
⁄
" open-ended wrench.
4
Advertisement
Table of Contents
