Advertisement
Contents
Connections
Power does not turn on / Power is turned off
Power is not turned on.
Check whether the power plug is correctly inserted into the power outlet. (v p. 25)
0
Power automatically turns off.
The auto standby mode is on. When approx. 15 minutes pass with no audio input and no operations on the unit, this unit automatically enters the
0
standby mode. To turn off the auto standby mode, press the AMP POWER X button for 5 seconds or longer. (v p. 43)
The power turns off and the power indicator shows one long blink and two short blinks in red.
Stop playback on the playback device, and then turn the power off and on again.
0
If the problem is not solved by turning the power off and on again, this unit's amplifier circuit has failed. Unplug the power cord and contact our customer
0
service center.
The power turns off and the power indicator shows one long blink and three short blinks in red.
This unit's power circuit has failed. Unplug the power cord and contact our customer service center.
0
The power turns off and the power indicator shows one long blink and four short blinks in red.
The protection circuit has been activated due to a rise in temperature within this unit. Turn the power off, wait about an hour until this unit cools down
0
sufficiently, and then turn the power on again.
Please re-install this unit in a place having good ventilation.
0
Check the speaker connections. The protection circuit may have been activated because speaker cable core wires came in contact with each other or a
0
core wire was disconnected from the connector and came in contact with the rear panel of this unit. After unplugging the power cord, take corrective
action such as firmly re-twisting the core wire or taking care of the connector, and then reconnect the wire. (v p. 16)
Stop playback on the playback device, and then turn the power off and on again.
0
The power turns off and the power indicator shows one long blink and five short blinks in red.
Stop playback on the playback device, and then turn the power off and on again.
0
If the problem is not solved by turning the power off and on again, this unit's amplifier circuit or power circuit has failed. Unplug the power cord and
0
contact our customer service center.
Front panel
Rear panel
Playback
Settings
47
Remote control
unit
Tips
Index
Appendix
Advertisement
