Advertisement
Contents
Connections
Setting the TV auto play function
Set this when playing audio from a TV on this unit. When the TV is turned
on, this unit turns on and the input source is automatically switched to
"OPTICAL 1", "OPTICAL 2" or "COAXIAL" so that the audio from the TV
can be played through this unit. Set this according to the connector on this
unit where the TV is connected.
TV AUTO-PLAY
Front panel
Rear panel
Playback
Settings
1
0 When the analog mode is set to "ANALOG MODE 1" or "ANALOG MODE 2", the
TV auto play function does not work. (v p. 30)
0 Depending on your TV, the TV auto play function may not work.
0 This unit will not automatically turn off when the TV is turned off.
0 The TV auto play function works when an audio signal is input to this unit, but if the
sampling frequency of the input audio signal is 88.2 kHz or more, the TV auto play
function does not work. TVs normally output 48 kHz audio signals and the TV auto
play function will work, but if you connect a device that outputs an audio signal of
88.2 kHz or more and try to use it, the TV auto play function may not work.
42
Remote control
unit
Tips
Press TV AUTO-PLAY to select the setting.
The setting changes each time TV AUTO-PLAY is pressed.
0
OPTICAL 1 / OPTICAL 2 / COAXIAL / Off
(Default: OPTICAL 1)
Index
Appendix
Advertisement
