Advertisement
Contents
Connections
Playing CDs
This section uses playback from a CD as an example.
1
Press the input source select button (CD) to switch the
input source to "CD".
"CD" is displayed on the display of this unit.
2
Playback the CD.
3
Press VOLUME df to adjust the volume.
o Playback in source direct mode
The signal does not pass through the tone adjustment circuitry (BASS,
TREBLE and BALANCE), resulting in playback of a higher sound
quality.
1
Press SOURCE DIRECT to turn on source direct mode.
The SOURCE DIRECT indicator lights.
Front panel
Rear panel
Playback
Settings
o Playback in analog mode
When the analog mode is turned on to playback an analog source
(PHONO, CD, NET/AUX, RECORDER, EXT.PRE), power to the digital
input circuit and the display turn off. This enables you to enjoy high
sound quality audio playback without sound quality being affected by
noise that occurs from the digital control circuit.
1
ANALOG MODE Off:
ANALOG MODE 1:
ANALOG MODE 2:
0 A digital input source (COAXIAL, OPTICAL 1/2, USB-DAC) cannot be selected
when analog mode is on.
0 The input source automatically switches to CD if analog mode is turned on during
playback of a digital input source (COAXIAL, OPTICAL 1/2, USB-DAC).
0 Communication between this unit and the computer is disconnected if analog
mode is turned on when a computer is connected to the USB-DAC input connector
of this unit. If the unit cannot communicate with the computer after turning analog
mode off again, disconnect and reconnect the USB cable or restart the audio
player on the computer.
0 When the analog mode is switched, the mute circuit is activated for about 5
seconds.
30
Remote control
unit
Tips
Press ANALOG MODE to turn analog mode on.
The ANALOG MODE indicator lights.
Press ANALOG MODE to toggle between "ANALOG MODE Off",
0
"ANALOG MODE 1" and "ANALOG MODE 2".
Analog mode is not used.
Turns the digital input circuit power off.
Turns the digital input circuit power and
display off.
Index
Appendix
Advertisement
