Heinner MG-W1200R Manual page 9

www.heinner.com
X. TOMATO JUICER
ASSEMBLING
1. Place the plastic screw locking ring into the sleeve.(fig.1)
2. Place the gauze into the sleeve next to the plastic screw lockingring.(fig.2)
3. Put the fixing ring through the sleeve and make it at the end ofthe sleeve.(fig.3)
4. Place the snake into the head, long end first, and turn to feed the snake slightly until it
is set into the motor housing.(fig.4)
5. Insert the shaft of the snake into the central axis of the screw.(fig.5)
6. Put the whole sleeve along with the fixing ring through the screw, then move the
fixing ring clockwise so that it being fastened tightly.(fig.6)
7. Put the plastic juice tray through the sleeve and make it on the suitable position.(fig.7)
8. 4-Insert the plastic screw into the hole of the sleeve, then move it clockwise until it is
properly fastened. Then place the plastic cover onto the sleeve.(fig.8)
Now the appliance is ready for juicing.
1360W, 50/60Hz, 220-240V
8