Table of Contents
Advertisement
1
INTRODUCTION
MAGIC EEC allows the conversion from ETI to EDI and EDI to ETI signals.
Typical applications are Ensemble Multiplexers, which cannot generate an ETI signal
anymore (e. g. Fraunhofer ContentServer), but which must be fed to the transmitter
via E1 lines with ETI or Ensemble Multiplexers, which only have ETI inputs/outputs
(e. g. Rohde & Schwarz DM001), but which are to be fed via IP lines with EDI.
The system has two LAN interfaces by default. These are freely programmable in
terms of functions, configuration, monitoring, SNMP and EDI input/output. The ETI
interface has one G. 703/G. 704 input/output each.
The system is configured via the PC software included in the scope of delivery and
displays the status of the ETI or EDI input data streams and all system parameters in
a very clear manner. All events are stored in the device in a log file, which can be
retrieved via the PC software or alternatively stored in a network folder.
MAGIC EEC supports SNMP v1/v2c protocol for connection to up to four independent
network management systems.
In addition, alarm messages can be output via eight potential-free and programmable
contacts. Alternatively, eight programmable TTL GPIO contacts are available.
4
Advertisement
Table of Contents
