Manual Mode - Tech Controllers EU-i-3 Plus OT User Manual

I.

MANUAL MODE

This function enables the user to check if every device works properly by switching on each device separately: DHW pump,
additional contacts and valves. In the case of valves, it is possible to initiate opening and closing as well as check if the
pump of a given valve works properly.
NOTE
Additional valves appear in manual mode only after they have been
Draw your heating system scheme including all active valves and devices connected to additional contacts. It will help
you to configure your heating system.
PART IV
Manual mode
Valve 1
Valve 2
Valve 3
DHW pump
Voltage contact 1,2
Voltage-free contact 1,2
Contact 0,10V 1,2
PWM contact
Additional valve 1-2
The same submenu as for Valve 1
The same submenu as for Valve 1
The same submenu as for Valve 1
registered.
27
Valve pump
Valve opening
Valve closing
Stop