Ryobi TSS701 Operator's Manual page 27

NESTING CROWN MOLDING AGAINST THE
MITER FENCE
See Figure 35 - 37.
NOTE: This method of cut is for crown molding up to 3-3/8 in.
tall, when using an auxiliary fence (as described on Page 24).
Do not attempt to cut molding that is larger than 3-3/8 in. tall.
 Assemble and attach auxiliary fence as shown in
figure 33.
 Align the arrow on the crown indicator with the arrow
on the pivot assembly and tighten the slide lock knob
securely.
 Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right. (For making 90° corners.)
 Nest and secure the crown molding against auxiliary fence
using a spring clamp and hold crown molding securely.
 Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Squeeze the switch trigger.
Allow several seconds for the blade to reach maximum
speed.
 Slowly lower the blade into and through the crown
molding.
OPERATION
AUXILIARY
FENCE
CROWN
INDICATOR
PIVOT
SPRING
ASSEMBLY
CLAMP
INDICATOR
CROWN
MOLDING
Fig. 35
27 − English
SPRING
CLAMP
BOTTOM EDGE
AGAINST FENCE
Fig. 36
Fig. 37