Installation And Connection; Installation; Electrical Connection; Supply (Plug Connection) - Balluff BAE SA-OH-064-NP-DP02 User Manual

BAE SA-OH-064-_P-DP02 / BAE SA-OH-064-_P-S75G
Photoelectric Sensors
5

Installation and connection

5.1

Installation

For dimensions, see Fig. 4-1 on page 8.
The following mounting types of the sensor amplifiers are
available:
– Simple clamp mounting on DIN rail with dimension of
DIN 35 mm or 15 mm.
– Clamp mounting on optional DIN rail adapter by means
of M3 threaded screws.
► Place the device on the DIN rail adapter as shown.
Connect cable.
Fig. 5-1: Installation of amplifier
5.2

Electrical connection

Depending on the model, the electrical connection is made
using a cable or a plug connection. The connection or pin
assignments for the respective version can be found in
Tab. 5-1 to Tab. 5-2.
See the information about Shielding and cable
routing.
5.2.1

Supply (plug connection)

Fig. 5-2: Pin assignment, M8 plug connector (top view of supply
plug connector)
Pin ...-NP-S75G
1 L+ (operating voltage +, 15...30 V DC)
2
3 L− (operating voltage −, 0 V, GND
4 NPN output
Non-assigned wires can be connected to GND on the control side.
1)
2) Reference potential for supply voltage and EMC-GND.
Tab. 5-1: Pin assignment, M8 plug connector
10 english
...-PP-S75G
Not used
1)
)
2)
PNP output
5.2.2

Supply (cable connection)

Color ...-NP-DP02
BN brown L+ (operating voltage +, 15...30 V DC)
BU blue L− (operating voltage −, 0 V, GND
BK black NPN output
Reference potential for supply voltage and EMC-GND.
1)
Tab. 5-2: Connection assignment, cable
5.2.3

Sensor

Fig. 5-3: Pin assignment (top view of sensor connector)
Pin
1 LED+ (transmitter)
3 FT+ (receiver/phototransistor)
4 GND (0 V/cable shielding)
1)
Reference potential for supply voltage and EMC-GND.
1)
Tab. 5-3: Pin assignment, sensor connector
5.3

Shielding and cable routing

The BOH sensor cable is shielded and should not
be extended.
The maximum supply cable length is 20 m.
...-PP-DP02
)
1)
PNP output
Signal