Table of Contents
Advertisement
To change the ventilator password in the mobile application, go to
Menu – Connection – Home.
1. Select the connection type and press the Settings button.
2. Enter and confirm the password.
Change Password
3. Press the
"Night
mode",
To set the
Menu – Settings – Timers
"Night mode"
The
timer sets transition time to the low speed after activation of the Night mode (8 hours
by default).
"Party"
The
timer sets transition time to the high speed after activation of the Party mode (4 hours by
default).
turn-off delay timer for the "Boost"
The
any sensor and reset of the sensor to the standard status.
To set up sensor operation via the mobile application, go to
Humidity sensor:
actuation of the humidity sensor. When the indoor humidity exceeds the set point, the
ventilator goes to the third speed. When the indoor humidity drops down below the set point, the turn-off
delay timer for the "Boost" mode is activated. After the delay timer countdown, the ventilator reverts to the
previous speed setting. Sensor 0-10 V: actuation of the analogue 0-10V sensor. If the 0-10 V control signal
exceeds the set value, the ventilator goes to the maximum speed. After decrease below the set value the
Boost delay timer is activated. After its operation is completed the ventilator reverts to the previous speed.
Relay sensor:
actuation of the external relay sensor. As the NO contact of the external relay sensor
is closed, the ventilator goes to the high speed. As the NO contact opens, the turn-off delay timer for
the "Boost" mode is activated. After the ventilator operation in the Boost mode comes to the end, the
ventilator reverts to the previous speed setting.
Note:
for activation/deactivation of the sensors and setup of the sensor threshold points for
TwinFresh Expert Duo ventilators in the Slave mode follow the steps:
•
turn the ventilator to the Master mode using the DIP switch No. 1 (refer to section "Positioning of the
DIP switch").
•
set the ventilator into the special setup mode (refer to section "Special setup mode")
•
connect the mobile device to the ventilator (refer to section "Connection of mobile application to the
ventilator")
•
set the sensors using the mobile application
•
exit the special setup mode
•
turn the ventilator to the Slave mode using the DIP switch No. 1
18
VENTILATOR PASSWORD CHANGE
button.
"Party mode"
timer and the turn-off delay timer for the
in the mobile application.
mode defines switch delay to the high speed after actuation of
TwinFresh Expert (Duo) R(M)W1-30/50/85/100(C1) V.2
TIMER SETUP
"Boost"
SENSOR SETUP
Menu - Settings
-Sensors.
1
2
mode, go to
www.vents-us.com
3
Advertisement
Table of Contents
