Table of Contents
Advertisement
DSP 3320i-ODS, DSP 3325i-ODS, DSP 3333i-ODS
User manual
Many DASS TECH inverter installation
100mm
3.5 Moving the DASS TECH inverter
This topic describes how to move the DASS TECH inverter to the installation position
horizontally
Procedure
Step 1 Opening the packing, insert hands into the slots on both sides of the DASS TECH
inverter and hold the handles, as shown in Figure 3-3 and Figure 3-4. Two persons are
required to move the DASS TECH inverter.
Figure 3-3 Moving the DASS TECH inverter (1)
200mm
21
DSP 3320i-ODS, DSP 3325i-ODS, DSP 3333i-ODS
User manual
Figure3-4 Moving the DASS TECH inverter (2)
Step 2 Lift the DASS TECH inverter from the packing case and move it to the installation
position.
To prevent device damag and personal injury, keep balance when moving the
DASS TECH inverter because the DASS TECH inverter is heavy.
Do not put the DASS TECH inverter with its wiring terminals contacting the
floor because the power ports and signal ports are not designed to support the
weight of the DASS TECH inverter. Place the DASS TECH inverter horizontally.
When placing the DASS TECH inverter on the floor, put foam or paper under
the DASS TECH inverter to protect its shell.
Attention
End
3.6 Installing the DASS TECH inverter
Step 1 To determine the position for drilling holes, level hole positions, and then mark the
hole position by using a marker, use the hammer dril to dril hole on the wall. Keeping the
hammer perpendicular to the wall, do not shake when drilling, so as not to damage the walls.
If the aperture errors, need to reposition.
Step 2 The expansion screw is vertically inserted into the hole, pay attention to expanding
screw insertion depth (not too shallow).
Step 3 Putting the rear panel on the wall, the rear panel is fixed by the nuts.
Step 1
22
Step 2
Step 3
Advertisement
Table of Contents
