Table of Contents
Advertisement
DSP 3320i-ODS, DSP 3325i-ODS, DSP 3333i-ODS
User manual
Outlines of this chapter
This topic describes how to install the DASS TECH inverter.
Installation notes
Do not install the DASS TECH inverter on flammable building materials.
Do not store the DASS TECH inverter in areas with flammable or explosive
materials.
Danger
Do not install the DASS TECH inverter in places prone to body contact because
the DASS TECH inverter shelf and heat sinks become hot during the DASS
TECH inverter operation.
Caution
Take the DASS TECH inverter weight into consideration when transporting
and moving the DASS TECH inverter.
Install the DASS TECH inverter in an appropriate position and surface.
Assign at least two persons to install the DASS TECH inverter.
Attention
3.1 Installation Process
This topic describes the process for installing the DASS TECH inverter.
3.2 Checking Before Installation
Before unpacking, check that the packing materials are intact. After unpacking, check that the
deliverables are complete and intact.
3.3 Tools
Prepare tools required for installation and electrical connections.
3.4 Determining the Installation Position
Determine an appropriate position for installing inverter.
3.5 Moving the inverter
This topic describes how to move inverter to the installation position horizontally.
3.6 Installing the inverter
Before installing inverter, secure the shipped rear panel to the wall. Then secure inverter to
the rear panel by using hexagon screws.
3
Installation
15
DSP 3320i-ODS, DSP 3325i-ODS, DSP 3333i-ODS
User manual
3.1 Installation Process
Figure3-1 Installation flowchart
Check before
Start
installation
Installation the
End
inverter
3.2 Checking Before Installation
Checking Outer Packing Materials
Packing materials and components may be damaged during transportation. Therefore, check
the outer packing materials before installing the inverter. Checking the surface of packing
materials for damage, such as holes and cracks. If any damage is found, do not unpack the
inverter and contact the dealer as soon as possible. You are advised to remove the packing
materials within 24 hours before installing the inverter.
Checking Deliverables
After unpacking the
inverter
, check whether deliverables are intact and complete. If any
damage is found or any component is missed, contact the dealer.
Check the list in the table 3-1.
16
Prepare installation
Determine the
tools
installation position
Installation the rear
Moving the
inverter
panel
Advertisement
Table of Contents
