Table of Contents
Advertisement
DSP 3320i-ODS, DSP 3325i-ODS, DSP 3333i-ODS
User manual
Tool
Model
R 45
J
Cable cutter
N/A
Crimping tools
N/A
Vacuum cleaner
N/A
Multimeter
N/A
Marker
N/A
Measuring tape
N/A
Level
N/A
0-180º
ESD gloves
N/A
Safety goggles
N/A
Anti-dust respirator
N/A
Function
2PCS
Used to cut power cables
Used to crimp power cables
Used to clean up dusts after drilling
holes
Used to check grounding
Used to mark signs
Used to measure distances
Used to ensure that the rear panel is
properly installed
Operators wear ESD gloves when
installing equipment.
Punch operator wearing
Punch operator wearing
19
DSP 3320i-ODS, DSP 3325i-ODS, DSP 3333i-ODS
User manual
3.4 Determining the Installation Position
Determine an appropriate position for installing the DASS TECH inverter.
Comply with the following requirements when determining the installation position:
Figure 3-2 Installation position requirements
OK
OK
NO
OK
NO
OK
OK
NO
NO
max 15º
80
cm
50 cm
50 cm
50
cm
Minimum installation distance for single DASS TECH inverter
20
NO
OK
Notice
Installation position has following requirements:
Installation position can not hinder power cutting off.
Installation wall should have enough load bearing capacity
Installation position should avoid child contact
NO
NO
Advertisement
Table of Contents
